huitianhaha

Comments

• Where does the Device Group ID in the Midi panel of Console Settings window used to ?

  in MSC command for scene ? Comment by huitianhaha October 2010
• sander;49794 said:that is strange, i am running midiox and hogPC connected with the virtual midiyoke lines. and in this configuration both IDs have to be the same, else hogPC will not listen to the generated MSC of midiox. Yes. in your example, the …

  in MSC command for scene ? Comment by huitianhaha September 2010
• oh,I tried it, but got a different result. I assign two different Device ID in the MSC and the Console, but the console also received the MSC normally and execute.(MSC Device ID must be 1, the console's Device ID set to other number). by the way, I …

  in MSC command for scene ? Comment by huitianhaha September 2010
• That's a special function belongs to hog. I'm not used to it about rpm at beginning, but now I like it more and more. that's a very good function.

  in rpm attribute problem? Comment by huitianhaha September 2010
• Is there any difference between "Device ID" in the MSC command and "Device ID" in the Console Settings -> Midi -> Device ID/Device Group ID on the console?

  in MSC command for scene ? Comment by huitianhaha September 2010
• sander;49759 said:you can send a MSC command to fire a scene, and you can even release a scene. to give scene 1 a go: F0 7F 01 02 01 01 00 31 00 05 F7 (31 in this string is the scene1) to release scene 1: F0 7F 01 02 01 0B 00 31 00 05 F7 (0B i…

  in MSC command for scene ? Comment by huitianhaha September 2010
• why the rpm needs to hold down "-" key and the pan/tilt doesn't need? That's convenient operate ?

  in rpm attribute problem? Comment by huitianhaha September 2010
• yes, hold down "-" key is ok. thanks.

  in rpm attribute problem? Comment by huitianhaha September 2010
• hi, mitch. How can i control scene use MSC command? thanks

  in MSC command for scene ? Comment by huitianhaha September 2010
• oh,i see, thanks mitch.

  in MSC command for scene ? Comment by huitianhaha September 2010
• oh. that's how it is. finished problem. thanks very much.

  in DP and Wysiwyg ? Comment by huitianhaha September 2010
• Thanks chris. That's a good idea, I'll try it if the condition is accepted. Could i please you post the fix answer here if you get. I've another question. how can i set the cuelist number or cue number to 22 , 333 or 4444 etc with the msc comma…

  in MSC command for scene ? Comment by huitianhaha September 2010
• hi chris. when double clicking on the dp in the device list, I cannot found the node number that you said, just a protocol, name and address I can assign. My wysiwyg version is R22, Is that so old? thanks.

  in DP and Wysiwyg ? Comment by huitianhaha September 2010
• That's the answer I want.thanks.

  in What's the "Show Pips"? Comment by huitianhaha November 2009
• Thanks. I think I understand.

  in what's the "sync type" and "sync to" effect? Comment by huitianhaha October 2009