Hi all,
there's a thing about the Hog 3 software that is very nerving.
When I have for example 10 fixture with the fixture numbers 1>10, and I want edit the numbers to 2>11:
I always try to mark all the fixture, pressing "set" and enter the 2 in the first cell.
Normally now the fixture numbers would be 2>11, but in this case the hog warns, because the numbers are already taken at this moment.
So the only way is to enter first a higher number like 12, to make the numbers 2>11 free for use.
Why the software doesn't realise, that the numbers are only taken by the fixtures that I try to edit at this moment?
Best regards,
Ben
