Pre-programming

Hello everybody! My name is Fredrik and I am from Sweden. I am a Hog-rookie. This is my first discussion here and my english is not that good, so I really hope you will understand what I am writing.

I have a fullboar 4 and until now I have always created a new show and made all the cues and programming in the venues. Now I am consider design/programming shows att home on hog 4pc + Light converse and export it to my fullboar 4.

If the pan/tilt positions for a group of fixtures are to high or low when I try my show at the venue, is there a way to adjust it for all the cues at the same time?

Do you have any other advices or tricks / is there something special I need to know about this?

Best regards
Fredrik Broberg

Comments

  • MLorenzMLorenz Registered User, Hog Beta
    NO... Not at the moment.
    Thats what presets/palettes are there for.
    Just edit all your position presets and you´re done
  • MitchMitch Registered User, HES Alumni
    Hi Fredrik, checkout video 6 at the link below.

    https://www.highend.com/hes-support/training/hog-videos
  • Strobie1Strobie1 Registered User
    When you programme you scenes cues and position effects, use a position preset as the Base. Then when you get to the venue you can update that preset and all the cues and scenes and effects that reference it will also update. Presets are used like this as the Base of all show information by every console.
Sign In or Register to comment.