IPC Software v3.0.3

This is odd. You are using the MSI, not the FPSPKG correct?

Hi Chris,
i did try the MSI file which looks as if all is well it starts to boot and all the progress screens look good,installation complete and the console reboots but it hasn't upgraded the Hog III software.
Can i try the FPSPKG file from the start screen?

Thanks for the quick reply.

[quote=cormacjack;38276]
Can i try the FPSPKG file from the start screen?


The FPSPKG is only for the Linux console.

Regards,

Hi Cormac, are you getting any error messages?

What Image version is installed in the console?


Thanks,
Mitch

Hi Mitch,
not getting any error messages.
Desk has just been packed up but i think the image is 8.2.2 if that makes sense?

Regards Cormac

Hi All,
thanks to Mitch for this but in case anybody else has this issue on an older IPC upgrading software.

1.Reboot the console
2.Press delete/del as the console boots
3.You will be asked for a password which is "hesipc"
5.You enter the bios section of the console
6.Navigate to advanced then chipset
7.Reduce the frame rate buffer size to 8mb from 32mb or a higer number to 8mb.
8.Escape and save your settings
9.Upgrade to Hog III 3.0.3
10.Reboot the console.

go thru to the bios selection again and increase the frame rate size back
to the 32mb....save again.

Sorry if i missed any steps.

Thanks Mitch for your help.