MIDI event question

fritznpopfritznpop Registered User
I am triggering HOG4PC cues via MIDI notes, inputting them to the computer via an M-Audio Uno input device. Everything is working fine, however the MIDI viewer shows a continuously repeating event:
"Could not get Midi Out device 1 capabilities so skipping.."
This event repeats forever. If I unplug the M-Audio Uno, it stops. When I plug the UNO back in it starts up again, but it now reads:
"Could not get Midi Out device 2 capabilities so skipping.."
This repeats indefinitely as well.
This does not appear to effect the operation of the cues at all, but I am not comfortable leaving this event without knowing if it could have a detrimental effect on the show over time.
Does anyone know anything about this? Is this something that I can make stop? Or do I have to even worry about stopping it?



  • MLorenzMLorenz Registered User, Hog Beta
    edited May 2014
    Dont worry about it....
    Did you configure the Midi Out as well or only the Midi in?
  • fritznpopfritznpop Registered User
    edited June 2014
    Thanks Marc- I took your advice and it has been running fine, albeit with that looping MIDI message. We did configure both the in and the out. We also tried not configuring the out, and only the in, but got the same results.

Sign In or Register to comment.