RoadHog Upgrade to 3.0.0

I just did a full system restore on my RH to 3.0.0, everything seemed to work fine. I loaded a new show file, and started patching fixtures. When I go to attempt to patch, the window indicated that I have a DP 8000, not a 2000 - and gives me 16 universes to choose from. This is obviously not correct.

Any suggestions?

0 sfeerpeer - Former HES Forum Member over 15 years ago

it's virtual, universe 1>4 is still output 1>4
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marty postma - Former HES Forum Member over 15 years ago

With v3 the two internal DP-2000 processes have been replaced with one DP-8000 process.

You still only have 4 outputs on the RH.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 uptownlighting - Former HES Forum Member over 15 years ago

Thanks. It surprised me that I could patch something into 5-8 (although there is no output). I did call HighEnd and spoke with Cat and she gave me the same info.

Thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 bradpepe - Former HES Forum Member over 15 years ago

Tom,

I am glad that Cat was able to help. FYI the release notes and the v3.0 manual also contain full descriptions of these changes to the software.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel