Timecode Jump Result

jabadgerjabadger Registered User
This may be as designed or an oversight. But, using the example below, if the console was sitting in a cue with a smpte time far beyond what is shown (say in the 4 hour range) and the timecode source stops at that hour mark and then jumps and holds to 02/45/00.00, I wouldn't want the console to go to Cue 2 and then perform the autofollows of cue 2.5 and cue 2.6. I'd expect the console to jump to cue 2.6. Currently the console jumps to cue 2 when the above scenario happens.



  • bradpepebradpepe Registered User, HES Alumni
    edited March 2006

    I think that it is jumping to the nearest timecoded cue that it can find in the list. I understand your point however and I will look further into this.

Sign In or Register to comment.