Power Up Problem

I have a Hog 3 in show. We have a intermentent problem on power up, where the screens stay dark and the blue lights on the fadders (Choose) flash. Any idea what may be causing this? Any ideas on what to do to fix this?
Comments
Do you have any external devices attached? Does the problem persist if they are removed?
Joe is correct that if the Choose LEDs are flashing then the front panel and the processor are not communicating. Please contact our support department directly at 800-890-8989 so they can walk you through some troubleshooting. You probably have something that is loose that is causing this fault.
Thank you for you help that sounds right to me. I will give the tech number a call.
- Michael
The flashing choose buttons mean the front panel can't talk to the console. If the console doesn't initialize the front panel within a certain period of time after power-up, it starts flashing the choose buttons to let you know it's not active.
i have the same problem..
im runnung 3.0.2
hog 3 full console
Both monitors stays dark when i turn power on but sometimes screens flicker few times. And i also managed to boot up console few times and it worked ok about 30min but then both screens went dark and after few minutes Choose leds starts flashing.
Has anyone found any reasons what is causing this? I´m running on 3.0.1 and no external devices connected. All connections inside are checked.
_______
ottot
This is what happens when the front panel loses connection to the processor board. If it is not a loose connection then it might be a bad wiring harness or worse cased something physically wrong with your processor board.
Hope this helps.