› ›

Self addressing.

ambi40ambi40 Registered User
edited June 2007 in Wholehog 3 General Discussion
When i address my studio colors or spots for example, so that i can
tech them for an upcomming show, my second batch of fixtures to be
tested take on the same addresses i have assigned to the last batch.
is there a reason for this occurence?. Thanks Again.


Ambie

Comments

  • cormacjackcormacjack Registered User, DL Beta, Hog Beta
    edited June 2007
    Hi Ambi,
    I don't understand your post?
    Are you trying to say that on the console when you patch the fixtures or the actual fixtures take the same address's?

    Cj
  • ambi40ambi40 Registered User
    edited June 2007
    Yes , what i am simply saying is that say i am going to tech
    some studio colors, i would address them accordingly correct?
    after i am done with the 1st batch of fixtures i would set up
    another batch to be tested i would power them up an after
    they home, for some reason take on the same address seaquins
    the others had. Why is that ?.


    Thanks Again.

    Ambie
  • jxgriffijxgriffi Registered User, DL Beta, Hog Beta
    edited June 2007
    It sounds like you just have luck of the draw with your fixtures. There is no communication between the board and fixtures to address or do anything to them. That MIGHT come later with more implementation of RDM, but, as of now, it must be pure luck of the draw.
Sign In or Register to comment.