how to Record On Stage output.

suck command needs selecting of fixture. i want to record total output as seen on stage.
Thank You

Choose all of your fixtures you want to record and hit 'Touch'

Alternatively hit your 'Output' view and select your fixtures that way, and that way you are less likely to miss one. Hit touch after selecting then record. I don't know another way to record all output, that's the way I'd use.

Press Live + Touch to bring all the output parameters in the programmer after you can record it.

Live + Enter brings all fixtures above 0% to the programmer. From there, select Suck or Touch, depending on if you want every parameter to have a hard value or not.

Hi,
Perhaps try Pig + Live,this will bring all values either above or below 0% into the programmer.

Regards Cormac

Pig + Live would want you to select a palette etc, but Live @ 0 thru 100 will grab everything. You could make a macro and add touch.

How can i capture artnet output from another desk? If it's possible it would to change desk for an old show.

unable to view catalyst media in the media picker with a windows 8 pc and a nano hog. It works very well with any desk, but...not with hog PC. Any idea? Did i forgot something in windows?

ArtNet Capture for show-transfer from other desks is not possible.

I have it working with Win7
Check that your Networks (HogNet and FixtureNet) are configuered correct. Try to seperate them on two differernt physical adapters.