broken programmer wing

Hi, I have a programmer wing that is not connecting to my pc. The pc only recognizes it as a generic usb hardware an not as a wing. If i connect it with the motherboard disconnected it recognizes it as a generic usb wing. Has anyone had the same experience and can tell me what to do?:1zhelp: Thanks!

0 marc lorenz over 9 years ago

Try to reload the firmware when connecting the USB:

press and hold the 2 most upper/left button.

See if this helps
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Xavier Spruit Bleeker over 9 years ago

thanks for the reply but it didn't work the only thing that has changed is that the lights of the position and beam buttons start to blink.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mitch - Former HES Forum Member over 9 years ago

If it is connected to a USB3 port on the PC, the ones with the blue color in the port, try changing it to a USB2 port.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Xavier Spruit Bleeker over 9 years ago

Hi Mitch i tried it on a usb 2 hub and there is no difference the lights are stil blinking and the computer stil says it's a generic usb device
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel