Viewing Output on Hog2PC

Hi,

Will the output window only show levels if a widget is attached? I've built a custom library and I was hoping to test it but don't have a widget or the actual fixture but was hoping to be able to either view it in the Output window or the Show DMX window.

Thanks
Eric

0 marty postma - Former HES Forum Member over 13 years ago

[QUOTE=erock;48855]Will the output window only show levels if a widget is attached?

That is correct...there is no real output to monitor without an output device.....you could also you a DP if you prefer.

Hope this helps. :)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former HES Forums Member over 13 years ago

It's been a long time since I did anything with 2PC, but you can try connecting to one of the visualizers that support 2PC. That might allow you to see raw DMX values. There are some visualizer demos available that may work if you don't own any of the visualizers.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel