Follow Trigger

Running 3.1.1 on a WholeHog 3 and (1) DP2000.

During Progamming the last few days I noticed the Follow Trigger was causing the previous cue (0 second fade) to show the "R" in the Wait column. The cue executed in 0 seconds but the "R" ran and then I got my follow. When I removed the follow, no more "R" on the previous cue.

I temorarily fixd it by using a Wait trigger instead.

I am heading back shortly and will test it on a new cuelist.
I will also check to make sure there are no fades or delays in the previous cue.

Will post my results.

0 christall - Former HES Forum Member over 14 years ago

It is using the assert time.

I did a test using 1 desk channel and a separate cue list. All other cuelists are released. Whatever I set the Assert time to is what the cue before appears to run and therefore messes up the Follow trigger. And, it's only when the cue before the Follow is 0 seconds Fade.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 robbie_bruce - Former HES Forum Member over 14 years ago

We have a defect in 3.1.1 that has already been addressed where we will always fade using a default 2s with follow cues. This will be available in 3.1.2 hopefully next week. As you have seen the work around is to make it a wait with 0 time.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 christall - Former HES Forum Member over 14 years ago

Thanks Robbie.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel