Offset value not displayed

ChanneldaveChanneldave Registered User
If I try to fan the offset of an Effect, the value on the lcd stays at 0. the fixtures themselves actually offset properly on stage.

If I use the offset wheel on its own, the value on the lcd changes. but if I use set + offset the value on the lcd does not.

using the latest software on a Hog 1k

Comments

  • bradpepebradpepe Registered User, HES Alumni
    edited December 2009
    Dave,

    This is a long standing problem on the Wholehog 2 software. As you noted, each fixture still gets its own correct value. If you were to cycle through your fixtures with the next key you would see that each has their own unique offset value. This is simply a display bug that can occur when fanning.
  • ChanneldaveChanneldave Registered User
    edited December 2009
    ok, good to know. Weird, I used to have a Hog 500 that did not have this issue.
  • bradpepebradpepe Registered User, HES Alumni
    edited December 2009
    It does not always happen.. it is just one of those intermittent things that can occur depending on many variables.
Sign In or Register to comment.