Strange copy bug 3.1.1

srautanesrautane Registered User, Hog Beta
HogPC 3.1.1

When I copy from fixture 211>224 to 221>224 or 224>221 the third destination fixture gets no value .
This happens when the source fixture is Mac250 Wash Extented.
The same happens also when destination is other type of fixture.

Comments

  • cmuenchowcmuenchow Registered User, Administrator, HES Staff
    edited November 2009
    Is a specific parameter not being copied over? Are the results any different if you simply copy 213 to 223?
  • srautanesrautane Registered User, Hog Beta
    edited November 2009
    First I had only intensity information on fixtures and that didn't copy...and the same happened with copying to desk channels also.
    After that I added position data to fixtures and that wasn't copied either.
  • srautanesrautane Registered User, Hog Beta
    edited November 2009
    I started a fresh show (fixtures added and patched) and I wasn't able to repro that...I'll be back with more info if I find the way to make this happen again.
    I'll check if that happens with old file when I get back to it.
Sign In or Register to comment.