IPC Software v3.0.3

cormacjackcormacjack Registered User, DL Beta
Name :Cormac jackson
Console : IPC
Software : 3.0.1 b2425

Hi,
I'm trying to upgrade a few IPC consoles from
v3.0.1 to v3.0.3 and am finding it very difficult to do.
The consoles will all take the IPCconfig panel and the DP8000 upgrade but not the HogIII software v3.0.3.

The consoles go thru the entire process of loading the software and reboot as normal but the software does not load for some reason?

I've tried using the FPSPKG file and upgrading from the start screen but can't get that to work either.
Any suggestions please...

Thanks Cormac

Comments

  • cmuenchowcmuenchow Registered User, Administrator, HES Staff
    edited May 2009
    This is odd. You are using the MSI, not the FPSPKG correct?
  • cormacjackcormacjack Registered User, DL Beta
    edited May 2009
    Hi Chris,
    i did try the MSI file which looks as if all is well it starts to boot and all the progress screens look good,installation complete and the console reboots but it hasn't upgraded the Hog III software.
    Can i try the FPSPKG file from the start screen?

    Thanks for the quick reply.
  • Joe BleasdaleJoe Bleasdale Registered User
    edited May 2009
    cormacjack;38276 said:

    Can i try the FPSPKG file from the start screen?

    The FPSPKG is only for the Linux console.

    Regards,
  • MitchMitch Registered User, HES Staff
    edited May 2009
    Hi Cormac, are you getting any error messages?

    What Image version is installed in the console?


    Thanks,
    Mitch
  • cormacjackcormacjack Registered User, DL Beta
    edited May 2009
    Hi Mitch,
    not getting any error messages.
    Desk has just been packed up but i think the image is 8.2.2 if that makes sense?

    Regards Cormac
  • cormacjackcormacjack Registered User, DL Beta
    edited May 2009
    Hi All,
    thanks to Mitch for this but in case anybody else has this issue on an older IPC upgrading software.

    1.Reboot the console
    2.Press delete/del as the console boots
    3.You will be asked for a password which is "hesipc"
    5.You enter the bios section of the console
    6.Navigate to advanced then chipset
    7.Reduce the frame rate buffer size to 8mb from 32mb or a higer number to 8mb.
    8.Escape and save your settings
    9.Upgrade to Hog III 3.0.3
    10.Reboot the console.

    go thru to the bios selection again and increase the frame rate size back
    to the 32mb....save again.

    Sorry if i missed any steps.

    Thanks Mitch for your help.
Sign In or Register to comment.