Hunging

Toshimi YanaseToshimi Yanase Registered User
edited May 2009 in Barco DML-1200
just question, I would like to hung 2-points (corner fixed pole).
too danger or some problem?
toshi

Comments

  • Marty PostmaMarty Postma Registered User
    edited May 2009
    Not really sure what your question is, but you should consult a qualified rigger if you are concerned with safety.
  • Joe BleasdaleJoe Bleasdale Registered User
    edited May 2009
    Are you concerned about the angle of the projector or actual fixture? I think this is what he wants. HES say not to hang a DL.3 on a strange angle.. could be the same thing..?

    Regards,
  • Toshimi YanaseToshimi Yanase Registered User
    edited May 2009
    Thank you for your help.
    Thank you Marty.
    just Fixture issue I want to hung by 2-doughty cramp.
    I want to know, is this possible or impossbible?
    Thanks,
    Toshi

  • Marty PostmaMarty Postma Registered User
    edited May 2009
    Okay I understand now....the user manual suggests hanging with 4 clamps and you want to hang with 2.

    This should be OK as long as your clamps are each rated to handle the full 170# of the fixture.
  • edited May 2009
    Hi Toshi,

    Please see the excerpt from the DML-1200 User Guide below. You can use the corner points, but it is recommended that you use 4 hang points.

    "Rigging points and rigging clamps

    Four slots are longitudinally (A) oriented and four slots are transversely (B) oriented. Each slot contains a rigging point of which the position in the slot can be adjusted depending on the size of the truss installation. The rigging clamps (C) can be attached to those rigging points, which allows an easy and fast physical setup of the device in a hanging configuration. The 4 corners contains also each a rigging point as well as 2 fixed positions in the middle of two sides.

    Warning: Always use four (4) rigging points, equally spread, to suspend the device."

    Best Regards!
    p
Sign In or Register to comment.