t-beam trouble

Dear All,

I'm having a bit of a problem with a technobeam. I just cleaned out my gobo sensor with some rubbing alcohol, and I'm still getting a 'lith error' message. I know the actual sensor is working because when I run the wheel through the sensor, it gives me an 'on' message. Does this mean I need to replace the motor? Am I headed down the right track or do I need to go elsewhere? Any advice and help would be greatly appreciated! Thanks!

:684:

0 woodj32177 - Former HES Forum Member over 15 years ago

Yea,
Probably replace the motor,
Does it feel stiff to turn by hand?
Were you having problems with it before you cleaned the sensor?
J.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 wrecker - Former HES Forum Member over 15 years ago

Yes. No, the motor doesn't feel overly stiff like the effects of viagra, but it's not as free as some of the others, which is why I didn't want to replace it unless I had to. Those gobo motors are pains to replace (because of their locations). Thanks very much.

Yea,
Probably replace the motor,
Does it feel stiff to turn by hand?
Were you having problems with it before you cleaned the sensor?
J.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel