Separating grouped paramerters

[quote=VisualRhythm]Hey,

I'm not new to the hog series, but I just started working with the road hog.
When programing I noticed that some parameters are grouped together.
for example:

atomics- rate and effect type are grouped
gobos and gobo rotation/index are grouped togeter.

Noe this is good when it comes to P/T for fine adjustment.

Is there a way to separate these?

I think there are only two ways to achieve this. 1) This would be to go [setup] [preferences] [programming tab]. Seperating parameters can be done from there. OR, 2) alter the wheelsets [setup] [user preferences] [wheelset editor]. However saying this, I am not entirely sure this will help your problems, if I am talking out of my rear, somebody please correct me.

If you don't want them to always be separated (say you just have a few pallets where you want them to be seperated) you can always knockout any unwanted parameters before recording. Hold the back-arrow key while touching the parameter wheel.