change fixture order in output window

Hi Peer I'm not sure if I get you right but here it goes.
If you want to change the order according to which you fixtures are shown just right click on the black border of each fixture type and a new window will pop up where you can choose among collapse/expand, invert sort, raise priority, lower priority. This way you can arrange your output window to your like. Once you're finish remember to record over your output view to being able to recall the new layout anytime you open it.
Hope this helps
Marco:hogsign:

Peer,

Marco is correct that you can use the aggregate bars to change the order by changing the priority. Section 13.3.2 of the User Manual/Help further explains the options.

will read and try, thanx

Peer

hi,

I changed the priority and the order of fixtures indeed changed. Then I saved the new view, but everytime I had all windows closed and picked my new view the order was changed, and I have to give new priority again. So is the new view corrupt, or something else happening?

Peer

Peer, think you're doing something wrong cause your view should retain all the information. I do suggest closing all your windows and opening just the output, change your priority to your like and eventually record a new view. close your output window and recall the view you just recorded. has your priority changed? Hope this helps
Marco:hogsign:

hi,

now it works, but with "human delay":
I adjusted the priority and saved the view. After closing all windows I pressed the view I just recorded, and all the windows came to the right position, but not the priority-order I gave in.... Then I pushed it again and the priority was correct.
So I have to push twice to get what I want, is that normal?

Peer