Updating to 3.0

LA7272LA7272 Registered User
Hi,
What's the easiest way to download 3.0 to a USB stick and load it into an IPC ?
I have a MAC. Also, can you save more than one show file at a time to USB ?

Thanks, LA

Comments

  • Joe BleasdaleJoe Bleasdale Registered User
    edited January 2009
    Instructions on how to make a bootable flash drive can be found at www.flyingpig.com
  • Marty PostmaMarty Postma Registered User
    edited January 2009
    Joe,

    You cannot use a bootable USB drive onthe iPC only on RH & RHFB

    Full install/re-image of an iPC must be done via CD.

    LA,

    Download the iPC config panel, and H3PC software. Expand the zipped files onto your USB, then first upgrade the iPC config panel, followed by the H3PC software.

    If you plan to use DP-8ks with you desk you will need to download and install an additional piece for this.

    Honestly woth v3 you would be better off re-imaging your desk with a Full/Clean install. Just make sure to backup your showfiles externally first.

    Hope this helps:)
  • Joe BleasdaleJoe Bleasdale Registered User
    edited January 2009
    Joe,

    You cannot use a bootable USB drive onthe iPC only on RH & RHFB

    Full install/re-image of an iPC must be done via CD.

    Appolgies, my mistake.
  • LA7272LA7272 Registered User
    edited January 2009
    So for a Clean restart, i can do it off USB ? Also is will going to 3.0 from 2.6. really make any differance ?

    Thanks,
  • Marty PostmaMarty Postma Registered User
    edited January 2009
    LA7272 wrote:
    So for a Clean restart, i can do it off USB ?

    No.

    For a clean install you must use the ISO disk image via CD.

    USB will only update the applications and not the underlying XPe software.
Sign In or Register to comment.