Desk Locking up and re-setting

philyusphilyus Registered User
Hi all.

1*Hog 3 running version 2.6.0 (b2071) However currently with a flat CMOS battery or so I have been told!

2*DP's running same software version.

All connected to each other correctly via a switch etc etc.

Desk patched and about to start programming however twice today and once yesterday the desk just locks up (no button response at all) then after a minute the desk re - boots.

Any ideas guys?

Thanks in advance

Phil

Comments

  • bradpepebradpepe Registered User, HES Alumni
    edited September 2008
    Phil,

    This certainly is an odd problem. What is your network setup? You should probably contact the support department directly at 800-890-8989 or support@flyingpig.com
  • philyusphilyus Registered User
    edited September 2008
    Brad..

    Got the desk swapped out and everythnig ok currently, I will leave it in the hands of the supplier to sort their desk out. Obviously was an issue with the desk as opposed to the network.

    Thanks

    Phil
Sign In or Register to comment.