3PC and ESP Vision Demo help needed

king2756king2756 Registered User
Hi, everyone,

I'm trying to install Hog3PC and the Vision demo on a new machine and I'm having issues. When I open "Vision 2 Demo" I get a Jands Vista Vision file (I think) which goes crazy when I'm outputting the Hog3PC demo file. When I open the Vision "Contest" file, I can only control three fixtures. Anyone know what's going on? I installed these same programs successfully several months ago and I think I followed the same steps this time around. Connectivity software is installed, I can't figure out why it is not working. I'm running Hop3PC v. 2.6.0 on an XP machine if this helps. Thanks!

Will

Comments

  • cmuenchowcmuenchow Registered User, Administrator, HES Staff
    edited August 2008
    If you load a different ESP vision file after the Wholehog connectivity driver has gone outputs active, you will need to use the reconnect button on the connectivity driver to re-establish control over the newly loaded vision file. Perhaps this is the issue?
Sign In or Register to comment.