Replacing iPC Fader

I figured it was going to be as simple as the H3 -- I took off the cover and realized that's not the case; Before I take off a million little screws, am I missing a magic clip or something to expose the faders?

I have the faceplate off (4 hex screws) but then I see no access to the faders. Any advise would be most helpful!

Thanks.

Stephen

0 mitch - Former HES Forum Member over 15 years ago

Hi Stephen, you will need to remove the Fader knobs and Encoder knobs. Then remove the 4 hex head bolts to remove the front panel from the console, which it sounds like you have done. There are about 12 or so black bolts holding the PCB to the front panel, remove these and you should be good to go.

Let us know if you have any questions.

Mitch
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel