TOUCHSCREENS

aranajoseluisaranajoseluis Registered User
i have aproblem
i installed the software 2.4
but. the touchscreens doesnt work. only with the mouse.
and..appear software 2.4.0- but the hard drive have the old files.

aranajoseluis

Comments

  • bradpepebradpepe Registered User, HES Alumni
    edited April 2008
    Jose,

    What console are you on? Did you just update or install a full XPe image? More information will be needed. Did you reboot? Have you tried to calibrate the touchscreens? Please contact our support department directly for further troubleshooting at 800-890-8989 or support@flyingpig.com

    thanks,
  • aranajoseluisaranajoseluis Registered User
    edited April 2008
    i have hog 3 full console
    and i installed full xpe image. gut 2.4.0
    i try to calibrate the touchscreens but doesnt response
  • aranajoseluisaranajoseluis Registered User
    edited April 2008
    ahh
    important note
    when i go to system info appear
    touchscreen firmware version -
    appear in -
  • jxgriffijxgriffi Registered User, DL Beta, Hog Beta
    edited April 2008
    If you have a full Hog 3, you should not be using the XPe image.

    http://www.flyingpig.com/support/hog3/downloads/release/index.shtml

    This is the full install...give that a shot.
  • aranajoseluisaranajoseluis Registered User
    edited April 2008
    sorry, was my mnistake

    i dont installed the sofwtware correctly
    now is fine.
Sign In or Register to comment.