A very good question...the only power info I could find for RoadHog was in the manual stating that is autoswitching from 100 - 240 VAC....no mention of draw though:confused:
A full H3 draws 75watts, so I imagine 100 watts is a fairly safe estimate for RoadHog.
I just put a Fluke 179 meter on the Road Hog Full Boar; my Road Hog is not here right now. The Road Hog Full Boar draws at start up 1.11 mA, at idle not launched into a show .99mA, launched into a show but not doing anything .99mA. There are no wings or monitors plugged into it. The Road Hog and the Road Hog Full boar should draw around the same amps.
