Hog2 & WYG

I have completed the wyg help file containing how to use Hog2 PC with Wyg... All goes well until I test the connection.

I can see SysEx messages in MidiOx so I know WYG is outputting MIDI data.

I have configured Hog2 PC to Midi in on port 2 and out on port 3 as requested by the tutorial.

BUT... when I select fixtures and enter autofocus parameters...nothing in Hog2 PC.

Any Ideas Folks?

Drew

0 mitch - Former HES Forum Member over 16 years ago

Hello, was Wyg installed on the PC before Hog PC? If not you will need to remove the Hog PC program and re-install it as it needs to see the visualizer program when being installed.

Have you selected MIDI IN in the Input Panel of the Hog 2 PC program?

A few times I have seen in the Windows Control Panel a default MIDI Controller enabled that will take priority. Disabling this may allow your MIDI Interface to take over.

Mitch
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel