I am trying to figure this out using the Entours. The Entour has two parameters on one wheel, Color and Spin. I can Fan the colors to get a random colors effect, but if I try to spin that random set of colors, it jumps to white and then starts spinning.
I can fan the Spin RPM and get a random effect, but this looks really bad if trying to do a slower color scroll.
Since these are colors wheels, I can't figure it out with the Effects Engine either. Any ideas?
Sounds like the best solution would be to build a chase. You could have them all change randomly or randomly select the fixtures that change. Plus that will give you theoption to use the Tap feature to control the speed of the chase. But make sure to use plenty of steps to make it "seem" random.
The best solution I used was using a Chase Cuelist, but only two cues. this is what I did
Cue 1 - Takes all the Entours are sets the Random Parameter to randomize the fixtures, but no RPMs so that the Random doesn't keep going.
Cue 2 - Uses the Spin function to start scrolling the Color Wheel, but it keeps the Random color set. I also used Reset On Release so it always goes back to the beginning.
