More X-Spot fun

I am beginning to think my professor was right when he said these werent worth the trouble. I have another issue. I have one X-Spot that has a MUCH larger circle of light than my other three. Also, when I set it to rotate lithos the other two rotate, but the third does not. It goes to the correct litho, and it will even cycle through the lithos, but it will not rotate a single litho.
These things are killing me!!! :Eyecrazy:
Mike
These things are killing me!!! :Eyecrazy:
Mike
Comments
The rotate problem could be the driver chip or it could be the motor. Most likely the motor, but you can just swoop the drivers on the board with a chip you know is working, Do this with the power turned off. This will help you narrow it down.
Mike
I would check the zoom, replace the motor if it seems bad, or driver chip,
Or I have had a lens or 2 sieze up over time...
that was expensive..
Good Luck!
Joshua Wood
although I don't see that motor fail too often, it doesn't work very hard, so it seems to last much longer.
Joshua Wood
Mike