Another Studio Command Issue

EsotericEsoteric Registered User
edited September 2007 in HES Automated Lighting
So, I have one Studio Command that pulls way more amperage than all the other units and throws a breaker whenever it turns on. Any thoughts?

Mike

Comments

  • Woodj32177Woodj32177 Registered User
    edited September 2007
    Sounds like the Lamp power supply is going bad,
    something with the power factor correction, if that makes sense with the electronic ballast...
    Thats what it would be on a cyberlight anyways...
    I would swap the LPS with another unit and see if the problem follows the supply,
    Good Luck!
    Joshua Wood
  • EsotericEsoteric Registered User
    edited September 2007
    If that is the case, is that a part I can order?

    Mike
  • Woodj32177Woodj32177 Registered User
    edited September 2007
    yes, but it is very expensive, you may be better off sending it in for repair.
    Joshua wood
  • EsotericEsoteric Registered User
    edited September 2007
    Cool. Also are there instructions for how to do this somewhere (ie in a manual?)?

    Mike
Sign In or Register to comment.