Axon image problems

MarkScottMarkScott Registered User
edited August 2007 in Axon
Hello,

I am currently running two axons, one for a Christie projector and the other for an LED wall.

I have noticed on the projector that there are artifacts appearing like triangles and other shapes.

When I see these I reboot the Axon but they come right back. It is not all the time and not always at the same spots...

Also the other night I was surprised to see the windows 'blue screen of death' projected all over the stage instead of the show content.

Any advice?

Comments

  • SBlairSBlair Registered User, HES Alumni
    edited August 2007
    Mark,

    The triangles are likely a hardware failure with the video card. We've seen a couple that are like that. If both your Axon's have the same video card models, you can easily confirm this by swapping them between units.

    A BSOD almost always indicates a hardware problem. If you have it happen more than once you should definitely get with our Support dept so we can take care of it for you.
  • MarkScottMarkScott Registered User
    edited August 2007
    Thanks Scott.

    I think you are right about the video card. I will check into it.


    Mark.
Sign In or Register to comment.