Show data that cannot be read with Wholehog2

Hi,
start a new show on Hog II console and try to merge the old show into it.
Have had this problem with macros created on Hog II PC and not able to load into Hog II.

C

Akito,

I will take a look at this today, but how are you creating your floppy for the Wholehog 2 console? Are you copying the show files with explorer to a floppy or saving directly to a floppy from Hog 2PC or Hog iPC? I have found that often it is better to save directly to a floppy than to copy to a floppy.

I will post my findings here after I test with your show file as well.

[QUOTE=cormacjack]Hi,
start a new show on Hog II console and try to merge the old show into it.
Have had this problem with macros created on Hog II PC and not able to load into Hog II.

C

cormacja,

To our regret, it did not go well in the method that had been proposed by you.
Because I am using Fixture that doesn't exist in Wholehog.
However, I hit on a new method by your proposal.

1. Start New Show and Patch Fixture what you need.
2. Save to Disk.
3. Load Show(What made 2)
4. Merge show.

I hope this method will go well.

However, I cannot test this method at once.

Thanks,
Akito

BRAD,

I tested both methods. (Hog 2PC and Hog iPC)
Move from Hog iPC to Hog 2PC via usb.
Then I am usually saving directly to a floppy.
and
I copying the show files with explorer to a floppy.

In addition, I am usually saving directly to a floppy.
I am expecting the method of your canceling this problem to be discovered.

Thanks,
Akito

I have found that the console doesnt allways read disks formatted on a pc. I would also recomend formatting the disk on the Hog II then taking that disk to the pc to save the show on.

Lee,

Thank you for reply.
You can evade the problem by the thing formatted with Dos mode.

ON Windows XP.
1. Click Start
2. Select "Run and type"
3. Type "format a:"(a is Change it according to the composition of PC. )
4. Insert the floppy disk in the drive.
5. Press Enter.

Hope this help
Thanks,
Akito