Can't find the Hog 2 Curve Editor on iPC

I'm trying to get to the Curve Editor on my iPC running the Hog 2 software and can't find it. Acording to the Hog 2 manual (p117) "press Setup followed by Curve Editor to open the window". I can't find any "Curve Editor" button on any screen.

I'm sure I'm missing something pretty basic but can't seem to figure out what.

Thanks,

Joe

0 woodj32177 - Former HES Forum Member over 16 years ago

If memory serves,
I believe the curve editor was only a Version 4 thing,
and since version 4 was never released it doesn't exist on the hog 2 software.
The manual however, did make it to version 4, even thought the software did.
If you look closely, you will also see things about fixture talkback and remote addressing.. both of which version 4 would do...
Of course, this is all from memory, so I could be off base..
Good luck!
Joshua Wood
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marty postma - Former HES Forum Member over 16 years ago

Joshua is correct....I think there used to be a v4 BETA floating around somewhere on the FPS site, but I think that got taken down years ago with the arrival of Hog-3.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 bradpepe - Former HES Forum Member over 16 years ago

You guys are all correct about v4 software. It was made unavailable as it was never going to be released.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel