New to Whole Hog III - Pan?

I am sorry i do not understand your first question?? But if you are asking how to recorad beam and positoin information into the same pallet. After pressing the record button in the bottum right screen you will see buttons that say use I, use P, use C, use B, use E, and use T. push the perramitors you want to save into the pallet and them sellect the dirrectory you want to save the info in. This is masking in all the info for the function IPCBTE. After you do that in the pallet you stored the info you will see in the top right cornner the letter PB for position and beam information.

If you want the DL.1 to hold the same keyston correction fro the content from the catalyst you might need to make several cues inbetween the starting cue and the ending cue. so every cue is keystone corrected to the position you want.

Sorry for the confusion.

Ignore my first question. My real question is based on the concept of panning. I know I can make multiple positions and cues, then follow them sequentially and create a panning effect. However, I was just wondering if whole hog III could have two points set and pan from one to the other.

Thank you for the aid!

Select the Layer and then move the Pan parameter (hold down pig so that it moves slowly).

Cyrus,

It is not possible to have the Wholehog 3 pan between 2 points using the effects engine. The current design of the effects engine allows you to apply an effect waveform to a base value that you set, so you are controlling the center point of the effect and not the end stops.

If you want to have a fixture pan between two points, you can make a cuelist with two cues that have the two positions. If you want this to run automatically as an effect would, you can make the cuelist a chase.

I hope this helps.

It does help. Thank you all for your help on this issue.
I am sure I will post more newbie questions shortly, so get ready!