Foot Pedel for hog1000

I'm not shure if im understanding correct, when you say that it is sending from channel 0 to 5.. that is very un-common midi practize.. most controllers send on one channel at a time, but on different midi notes, or midi "controll channels".. if your device sends on one channel, but sends noteon values on notenumber 1 to 5, it's easy..
then you can just change whats in midimap file(in your show folder,you need to take it to a computer, and change the file with a text-editor) to this:
version = 40
; NB: MIDI Note & Controller numbers range from 1 to 128
go:1 = note:1
go:2 = note:2
go:3 = note:3
go:4 = note:4
go:5 = note:5
go:6 = note:6
go:7 = note:7
go:8 = note:8


If your device is sending noteon command on same note number, but on different midichannels, it's a bit more complicated, and the hog don't understand that, as it can't differ the noteon values from the different channels.. It is possible though, but it involves a computer between the desk and the midi device, to translate into something hog understands..

-Feel free to email me directly if you need further explanation..

hi

well i didn't explain all facts, it has 5 buttons and button 1 sends note 000 button2 send note 001 etc, so one note a button. i've tried the example you sendt me but can't get it to work, is there something i should change in the desk, in the midi config?


Best Regards Niklas Huke
Spectra+ Stage & Event Technologies
Sweden

I forgot to say that you need to enable midinotes in.. press setup, and choose input panel, and enable "midi in" and if you dont know which midichannel you sending on, set notes rx to channel 0(that make it listen on all channels.)

ok thanks i'll try that on monday.

Best Regards Niklas Huke
Spectra + Stage & Event Technologies
Sweden