Rotating Gobos

rigbybmjrigbybmj Registered User
Hey Guys,

I was able to get MAC 500 gobos to constantly rotate when on an actual Hog 2, but on the Hog2 PC I can not figure out how to get the gobos to constantly rotate in Martin Show Designer. Any ideas?

Thanks a ton!

Jay

Comments

  • stephlightstephlight Registered User
    edited October 2006
    Hi,
    try to see if you have selected gobo in mode index or rotation mode, this is on gobo wheel parameter, when you are on open position turn on right for gobo index, on left for gobo rotation mode

    hope this help
    steph
  • teericksonteerickson Registered User, HES Alumni
    edited October 2006
    Jay,

    I don't have a MAC500 in front of me, but I believe Steph is correct. Here's what I'm seeing in the DMX protocol and within Hog 2PC:

    You have 2 parameters for the first gobo wheel: Gobo and Gobo <>.

    When Gobo is set to gobo1, gobo2, etc., dialing the encoder for Gobo <> will index the gobo.

    If you dial Gobo *down* from the open slot, you will see entries for >>gobo1, >>gobo2, etc. With one of these values chosen, dialing the encoder for Gobo <> should rotate the gobo.

    I hope this helps.
  • rigbybmjrigbybmj Registered User
    edited October 2006
    Pefect! Got it to work, thanks! Still having touble with the CMY on handles though....

    Jay
Sign In or Register to comment.