Merging Palettes into new show

Hi, I created a bunch of palettes that I have since merged into other shows. Specifically the ones that i'm having an issue with are CXI color values. When I send the CXI's to a color, they end up about 1 DMX % level short of being fully in the frame of color. So for instance if red is front string 30 and back string 46, it will be front 29 and back 45. The only solution I can think of to fix this is to re-record all of the pallettes, is there any other way to fix this or has anyone else encountered this?

Thanks
Eric

0 Cormac Jackson over 17 years ago

Hi,
I have not had this problem but a few possible workarounds could be.

1.Check all the scrollers are calibrated correctley and the same.

2.You might try editing the fixtures in the patch of Hog II
set-up,patch,edit fixtures,set to change values
You may be able to edit the colour range so they default to a higher or lower percentage.

3.Load each colour pallette and edit the colours so they are correct in your new show which won't take long and will probably be best in the long run.

Good luck
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel