Question concerning gobo & color rotation/spin

a_sezaka_sezak Registered User
I am using an iPC on the Hog 3 platform and am unable to get the gobo's to rotate couterclockwise. The same applies to gobo wheel and color wheel spins. The parameter wheel only allows me to go from 0rpm's to 300rpm's but not to -300rpm's. In the "Edit Fixture" window the parameters are set to range from -300 to 300 but it is not working. Is there a way around this problem.

Thanks.

Comments

  • teericksonteerickson Registered User, HES Alumni
    edited September 2006
    If you hold down the minus key on the numeric keypad and then touch the encoder for the parameter that you're adjusting, this will place you in the negative range of values for that parameter.

    I hope this helps.
  • a_sezaka_sezak Registered User
    edited September 2006
    Great! Thanks.
Sign In or Register to comment.