X-Spot address problem

SaucemanSauceman Registered User
edited May 2006 in HES Automated Lighting
We have some X-Spots on a show at present.
One of the units operates as it should but when it is turned off at the end of the show and then powered up agian for the next show, it resets its DMX address back to 1. It is running in reduced mode. (Unsure of the software version)
Any explaination or solution would be grateful,
Thanks Lawrie

Comments

  • Marty PostmaMarty Postma Registered User
    edited May 2006
    Are all of your fixtures in the link running the same firmware version?

    If not you may need to crossload from the most current one.
Sign In or Register to comment.