› ›

sACN Bug - Not Sending Full Packets

Playdoe9Playdoe9 Registered User
in Hog 4 Networking Help
When running sACN from a single widget with a PC, I am seeing that the console only sends partial sACN packet up to the address you are using unless you manually make channel 512 have a value of 0.
Then once you clear channel 512 it sends the full packet until reboot.

Upon reboot, it will exhibit the same behavior. 

It should always be sending full packets.

This was seen and tested on sACN Viewer

Comments

  • Playdoe9Playdoe9 Registered User
    So I was on 3.15. The bug is not present on 3.17. So it has been resolved.
  • Michael_GrahamMichael_Graham Registered User, Super Moderator, HES Staff
    edited January 18
    Hello,

    Thanks for the information. As you found this is no longer an issue in 3.17.0. The issue was addressed in the 3.16.0 release.

Sign In or Register to comment.