Whole Fixture selection abnormality

We have a number of X4 Bars in a mixture of X4 20's and X4 10's, they are numbered as to their position on the truss and not by type.
When I select the whole group and use "fixture+Next" to step through whole fixtures once I have gone past a X4 10 it will only select half of an X4 20!

0 mitch - Former HES Forum Member over 4 years ago

Hi, which mode is being used for both fixtures? I will confirm and let the software guys know if there is a problem. For example, Normal mode, Compressed mode, etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Noah Allen over 4 years ago

Hello,

This is expected behavior according to the specification of the design.

Software development is aware that many users would prefer it to select by the entire whole fixture, rather than by the parts of the previous. A re-work is being considered for this behavior, and is currently logged as R-0145.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel