Default position of the moving head

Hi,
The default position (0 at pan and 0 at tilt on RH4) of my moving head is not parallel with the base.
image

Is there anyway I can offset the position of this moving head so that it is parallel with the base?
image

Would i able to edit the fixture library? (creating a cue for permanent solution is not ideal)

Thanks again for any input. =)

Comments

  • ejberendsenejberendsen Registered User, Hog Beta
    In edit fixtures you can set change the default pan value or you can set an offset value on the pan.
  • MLorenzMLorenz Registered User, Hog Beta
    I would go for the offset, as then your programming wont change. So you can easy swap fixtures.
  • mutanguymutanguy Registered User
    Thanks a lot
Sign In or Register to comment.