Bug: DMX Testing unpaches channels of already patched Fixtures

3.6.1. Roadhog. If you have allready patched Fixtures in the console and using DMX Testing output on every channel, it happens that some channels (e.g. Pan/tilt) getting unpached on its own. If you patch it new, it works again.
I can't reproduce the fail till now.

0 jory - Former HES Forum Member over 6 years ago

How are you testing the dmx? From the dmx window? After you entered something in the dmx window, you have to put that column back to hognet input.
Hope this helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 fino - Former HES Forum Member over 6 years ago

Hey yes i did from the DMX Window. Yes i did "back to Hognet input" but the colloums have been clear. there was even not a 0 i it anymore like the unpached channels
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 colin wood over 6 years ago

Was this an older show file? I have not seen this with a new show, but I have a couple of very old shows where this has occasionally happened.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 fino - Former HES Forum Member over 6 years ago

no I created this showfile on 3.6.1. for the last tour. So I’m very sure it’s a file rootly based on the 3.6.1.. I haven’t reproduced it till now.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rautasami over 6 years ago

I have had this too and I was advised to paint all cells from 1 to 512 and press Set to Hognet input.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel