Aetnet

I have a arena show coming up and the ME is using a S400 PRG rig and I have NEVER configured my DP8000 to send Artnet
I have always run copper 5pin out of the DP's to the rig.
The S400 rig takes Artnet from the DP's to a fiber switch then sends is to nodes.
As I have never set it up this way before I am a little bit nevy .
Can any one out there who knows how to set this up reply I can send the S400 system in PDF I just need to know a
Shure shot way to set the console up I will be running 2 H4's and to DP's first DP net 11 UNI 1>8 second Net 12 9>16

Thanks for you time lampfairy@me.com

0 jxgriffi - Former HES Forum Member over 7 years ago

You just enable the Artnet output in the DP window. Make sure all DP's are connected to an artnet switch. Setup your IP/Netmask and you should be good to go.

I like to use "Artnet Viewer" on my mac to confirm all universes are being sent.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marc lorenz over 7 years ago

Did you make it work?
Got no more response from you
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 nibor over 7 years ago

yes thank you all was grate with the 3.6.1 update 4 days of hard programing but there was something strange on the last easy day.
I this was not related to Artnet a cue would randomly drop out and the lights would drop ? it would not happen every time ? then when the shoe was over and 50 VIP's were on stage I pulled down a IFCB handle and as I moved it , it went to 0% instantly ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 nibor over 7 years ago

That's Show not shoe, Drrrr
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel