Add plot selection in command line

Hello,

A friend of mine pointed out to me yesterday that whe we made a selection in a plot It did not appear in the command line.It would be very useful to add that point, because we can't use functions, like copy, by making selections in plots views.
Thanks
Best
Stephane

Michael Graham over 8 years ago

This should work, I just selected two units in the plot (104 105) and put the intensity to full and in cyan.
I just then it copy to 107 and 108 enter and both fixtures went to full and in cyan.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
stephlight - Former HES Forum Member over 8 years ago

Thanks I Will try again, it was not working on my Hog PC.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
stephlight - Former HES Forum Member over 8 years ago

Do you have selected 107 and 108 on the plot?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
stephlight - Former HES Forum Member over 8 years ago

My friend test today, it is impossible to select fixtures on plot, press copy than select destination on plot.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
marc lorenz over 8 years ago

Michael, I guess you typed in the fixture-numbers.
Stephane wants to select the target fixtures in the plot
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
stephlight - Former HES Forum Member over 8 years ago

Yes, that is exactly the point! Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Michael Graham over 8 years ago

You are correct selecting the target fixture in the Plot will not work, you must use the Command Line to finish the copy.
I will get a request logged for this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
stephlight - Former HES Forum Member over 8 years ago

Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
rautasami over 8 years ago

+1 for this request. I also tried to use the plot that way a couple of weeks ago. Found it would be very handy if it works.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel