fixture profile for china lamp ??

hi guys,

I'll do a show tomorrow, Friday. With a copy of a Claypaky Sharpy from china.
Fortunately, it is not mine ....:-)
They run fine on a martin light jockey, with a Sharpy profile. but on my hog 4 works only dim - pan - tilt - strobe ...

they called 200 beam or something in china ..

Does anyone have a solution to the problem ??
I have seen the data sheet through and they should be the same with Sharpy profile on my hog 4

Thomas

marc lorenz over 9 years ago

Try to take the sharpy as the source in the fixture builder and make a new fixture with the dmx sheet next to you... too many copies of sharpys around...
Are you sure they are in the same mode on the light jockey?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
scharling - Former HES Forum Member over 9 years ago

hi,
I'm almost sure that it is the same .. lamp uses 16 ch in light jockey, and also the same on the hog profile ...

I know it can be tricky, but the parameters are the same ... it's so strange ..

The only Sharpy profile I have in the console are those with recent
update 2.4.0. And it's a Sharpy standard .. like in light jockey ..

the Sharpy copy should also work on chamsys. Without problems.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
marc lorenz over 9 years ago

Which parameters are not available?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel