Tracking H4 Macro troubles

BenwinBenwin Registered User, Hog Beta
Our current festival setup is 2 H4's one FOH and one on stage and 2 DP's on stage, FOH H4 is 172.31.0.1 stage H4 is 172.31.0.10 both desks set to Net #1 and server running on both to allow tracking in case of problems with FOH H4.
Each page has our main list triggered by SMPTE brought in to the network via LTC widget connected to on stage DP.
In the comment macros for each page we have a "DOT" macro and then "ET1234" etc, when I run through pages with just FOH H4 connected to network time code is enabled just fine.

When the stage H4 is connected the comment macros on each page don't always run! For some pages we also have comment macros to raise/lower master intensities, these do not always fire as well due to the festival situation it is not easy to fault check.

Has anyone else experienced this issue?

B

Comments

  • Michael_GrahamMichael_Graham Registered User, Super Moderator, HES Staff
    We have found a defect in the 2.3.0 release that would not trigger RA comment macros 100% of the time.
    We are working very hard to get this fixed before we release 2.5.0.
  • BenwinBenwin Registered User, Hog Beta
    If I run the backup console as net number 2 am I right in thinking if the main console (net 1) goes down and Net 2 takes over all the comment macros will be appended with "h1" at the end and so therefore not trigger?
Sign In or Register to comment.