Nano hog not recognized

Every time I plug in my nano, windows pops up with a warning that it is "not recognized" and I need to unplug and plug back in. When I plug back in, it just gives the same message. The super widget output works fine, it's just the programmer/playback wings that don't work.

MacBook pro, windows 8

0 jxgriffi - Former HES Forum Member over 10 years ago

Thomas,

You might have had a problem during installation of the drivers. When plugged in, go into the control panel and actually remove the instance of "not recognized." You might want to try reinstalling Hog4PC again just to make sure it loads the proper drivers.

Also, are you running under Parallels or Bootcamp on the Mac?

J
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mike_a - Former HES Forum Member over 10 years ago

www.highend.com/support/controllers/documents/Nano_Hog_4_Wing_Troubleshoot.pdf

Try the steps in the above link.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel