ELC NODE 8

HI GUYS,
So I have connected my road hog to the Node, the node to the Mac pro, opened the windows session in parallels, opened the ELC manager, the node is connected and the program receives dmx information.
Then I open WYG R28 go to live, try and connect my Node, but nothing goes, always "could not connect the following console:..."

any ideas???

Jon:hogsign:

0 marc lorenz over 10 years ago

Why do you go via the ELC-Node?!

Cant WYG R28 no longer connect direct to HOGNET?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jondbo - Former HES Forum Member over 10 years ago

Well the Road hog only has DMX outputs so I do not see how I could not use the Node?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 stefanwolf over 10 years ago

the road hog has ethernet too!
use an ethernet cable and connect it to your pc!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marty postma - Former HES Forum Member over 10 years ago

[QUOTE=JonDBO;68292]Well the Road hog only has DMX outputs so I do not see how I could not use the Node?

Are you on a RoadHog-3 or a RoadHog-4?
You are posting in the H4 section of the forums so we are all assuming you have an H4 based desk, but your description sounds like it might be an H3 based desk instead....
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mikeyray - Former HES Forum Member over 10 years ago

also its good to get the luminex wygaliser for connecting artnet to wyg
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel