1.2 can't work with hog3 file

ken1015

it is hog4 pc problem
when I swith to command mode and log show again.
it will close hog4 automaticly.
just like I run 337.
I'm not sure RH4 has sameproblem..
so please check this problem...

one more problem..
I can't see high end system website in Taiwan.
I try to used another computer.
but it can't work...

someone can tell me how can I do

MLorenz

Try to merge your hog 3 show into a empty hog 4 show
Also do a check integrity after that merge or the first load of a 3-show on a 4-consoles

ken1015

I can't test RH4 now..because it is on the ship...
and I just do some test..
full mode can work good after switch command mode..
and the 3's file can work good in merge show...
I think we still need fix this problem..
because some show data still in hog3.

anyways thanks for reply

MLorenz

There had been some issues with showfiles created on H4PC in Nano Mode and then opened on a Console.

Did it work when you merge the showfile, instead of opening it directly?

ken1015

merge show file is work..I can switch to command mode and log again..

MLorenz

This something I always recommend:
When a major-revision has changed, load the show not direct, merge it in.
I know, at the moment still it needs to be repatched, but some problems dont pop up then.
So now you have a working file... Might also be a problem with your showfile before...

JABOE

Hi Ken,

There have been some issues accessing our website in a some far east countries. The only way is, if you could provide us a gateway IP address and we will open access to this IP range for you access.

Can you provide this?

Regards,
Jamie

ken1015

thanks marc
I will always remenber that...
to jamie ...how can I provide IP ..I'm not really understand that..
maybe you can email to me in chinese..